how to hull black walnuts

Put the last load through it today, needs some tweaking (larger exit hole and full shaft length paddles). A 24-28 pound bucket of hull-on walnuts turns into about 12 pounds of hulled walnuts, with the count of 120-125 nuts. The night picture was the result of only two hours with my dad, and the day picture was the addition of what he had picked by hand the next day. I took the other 3 sacks (88.1 pounds dried) and they charged me a 15% weight fee to crack (13.2 pounds). Throw a bunch of walnuts in it with some old chain or angular gravel and you will have some super clean nuts. Stomp on the walnut with your foot and twist the nut into the asphalt surface. Walnut hulls will stain your hands, your clothing, and your work surface. wikiHow is where trusted research and expert knowledge come together. The shell of black walnut is extremely hard to crack and the nutmeat comes out in pieces. Before storing kernels at room temperature, bake them at 215 degrees Fahrenheit (101 C) for 10 to 15 minutes. This is the route I am going for next year, and I am a much better forager than processor. Use the kernels within a few weeks. Put them in a pail of water, not too many, swirl them around, fish them out and dry them on a flat surface where they don’t touch. Last Updated: April 2, 2020 Soaking the nuts will prevent the kernel from being shattered during the process of removing the shell. In a bygone era, they might have been celebrated for these attributes, but today they’re despised for denting parked cars and ruining mower blades. Hopper on top. I would change out the water three times, and the fourth time add a little bit of creek sand to get the nuts mostly clean. Walnuts have multiple layers, including the outer hull and the nutshell. "IF" you have a concrete mixer, this would be a great use for it. I have taken measurements to let you know how much nut meat you can expect to get. 10.8 pounds meat/104 = .1 pound meat for every pound of dry nut, or 1.6 ounces of meat per pound of dry nut. Frame is a carryall and hooks up with a very short PTO attachment. I was not going to drive over them, I tried the hand crank corn sheller (not efficient or effective), hand hulling (lots of time involved, hull has to be mostly black), and just knew there was a better way. {"smallUrl":"https:\/\/www.wikihow.com\/images\/thumb\/0\/0f\/Hull-Walnuts-Step-1.jpg\/v4-460px-Hull-Walnuts-Step-1.jpg","bigUrl":"\/images\/thumb\/0\/0f\/Hull-Walnuts-Step-1.jpg\/aid1868218-v4-728px-Hull-Walnuts-Step-1.jpg","smallWidth":460,"smallHeight":306,"bigWidth":"728","bigHeight":"485","licensing":"